SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014SANTA FE GLS, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEMCVVT OIL CONTROL VALVE (OCV)REPAIR PROCEDURESREMOVAL[CVVT OIL CONTROL VALVE (EXHAUST)]
2014 Hyundai Santa Fe GLS, FWD

[CVVT Oil Control Valve (Exhaust)]

2014 Hyundai Santa Fe GLS, FWDSECTION [CVVT Oil Control Valve (Exhaust)]
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).

    [Bank 1] 

    Fig 1: Identifying CVVT Oil Control Valve Connector (Bank 1)
    G09270826Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2] 

    Fig 2: Identifying CVVT Oil Control Valve Connector (Bank 2)
    G09270827Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the cylinder head cover.

    (Refer to "CYLINDER HEAD COVER ")

  4. Remove the installation bolt (A), and then remove the valve from the engine.

    [Bank 1] 

    Fig 3: Identifying Cylinder Head Cover Mounting Bolt (Bank 1)
    G09270828Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2] 

    Fig 4: Identifying Cylinder Head Cover Mounting Bolt (Bank 2)
    G09270829Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.