2014 Hyundai Santa Fe GLS, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the battery and the battery tray.

    Refer to BATTERY .

  2. Remove the under cover (A).

    Tightening torque:Β 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

    Fig 1: Identifying Under Cover
    G09270860Courtesy of HYUNDAI MOTOR AMERICA
  3. Drain the coolant.

    Refer to COOLANT .

  4. Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

    Drain plug tightening torque:Β 

    38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

    Fig 2: Identifying Drain Plug
    G09270861Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.