2014 Hyundai Santa Fe GLS, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console.

    Refer to FLOOR CONSOLE ASSEMBLY .

  2. Remove the air duct.
  3. Disconnect the sports mode connector (A).
    Fig 1: Identifying Sports Mode Connector
    G09270954Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the shift cable (A).
    Fig 2: Disconnecting Shift Cable
    G09270955Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the shift lever assembly (A) by removing the bolts (C-4ea).

    Tightening torque:Β 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 3: Identifying Shift Lever Assembly And Mounting Bolt
    G09270956Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.