2014 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the center console.

    (Refer to FLOOR CONSOLE .

  2. Disconnect the sports mode connector (A).
    Fig 1: Identifying Sports Mode Connector
    G09789642Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the shift cable assembly (A) from the shift lever assembly.
    Fig 2: Removing Shift Cable Assembly From Shift Lever Assembly
    G09789643Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift lever assembly (A) by removing the bolts.

    Tightening torque: 

    7.8 ~ 12.7 N.m (0.8 ~ 1.3 kgf.m, 5.8 ~ 9.4 lb-ft)

    Fig 3: Identifying Shift Lever Assembly
    G09789644Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the clip (C).
  6. Remove the shift cable (A) from the inhibitor by removing the nut (B).

    Tightening torque: 

    12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

    Fig 4: Identifying Shift Cable And Nut
    G09789645Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the shift cable assembly (B) by removing the nuts (A).

    Tightening torque: 

    6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

    Fig 5: Identifying Shift Cable Assembly And Nuts
    G09789646Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.