SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014EQUUS SIGNATUREREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (3 OF 3)DTC P2610: ECM/PCM-ENGINE OFF TIMER PERFORMANCEDTC INFORMATIONDTC DETECTING CONDITION
2014 Hyundai Equus Signature

DTC Information: DTC Detecting Condition

2014 Hyundai Equus SignatureSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • Soak time counter error
  1. Poor connection
  2. Open or short to ground in power circuit
  3. Open or Short to ground in signal circuit
  4. MAPS
  5. PCM
EnableConditions Case1
  • Engine "ON" is higher than 10 sec.
  • Battery voltage is higher than 8V
Case2
  • The internal memory is normal.
Threshold value Case1
  • The deviation between the value by LPC and the value by internal counting is higher than 10 sec
Case2
  • LPC is reset to "0" abnormally.
Diagnosis Time
  • -
MIL On Condition
  • 2 Driving Cycles

* LPC (Low Power Counter): Time counter after IG OFF

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.