Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014EQUUS SIGNATUREREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYENGINE CONTROL/FUEL SYSTEM - GENERAL INFORMATIONSPECIFICATIONSACTUATORS
2014 Hyundai Equus Signature
Engine Control/Fuel System - General Information: Specifications: Actuators
2014 Hyundai Equus SignatureSECTION Actuators
Injector
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 1.08 ~ 1.23 [23°C (73.4°F)] |
ETC Motor [integrated into ETC Module]
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 1.2 ~ 1.8 [20°C (68°F)] |
Purge Control Solenoid Valve (PCSV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 14.0 ~ 18.0 [20°C (68°F)] |
CVVT Oil Control Valve (OCV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 6.9 ~ 7.9 [20°C (68°F)] |
Fuel Pressure Control Valve
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 0.47 ~ 0.51 [20°C (68°F)] |
Ignition Coil
- Type: Stick type
- Specification
| Item | Specification |
|---|---|
| Primary Coil Resistance (Ω) | 0.62 ± 10%[20°C (68°F)] |
| Secendary Coil Resistance (kΩ) | 7.0 ± 15%[20°C (68°F)] |
Canister Close Valve (CCV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 23.0 ~ 26.0 (20°C) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.