Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014EQUUS SIGNATUREREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPOWER TRUNK MODULEPOWER TRUNK MODULE DRIVE UNITREPAIR PROCEDURESREMOVAL
2014 Hyundai Equus Signature
Repair procedures: Removal
2014 Hyundai Equus SignatureSECTION Removal
CAUTION:
- When removing and installing the trunk lid, an assistant is necessary.
- Take care not to be closed the trunk when removing the push rod.
- Wear gloves to protect hands from injury.
- Disconnect the negative (-) battery terminal.
- Remove the left trunk trim in the trunk. (Refer to the TRUNK TRIM .
- Remove the power trunk connecting rod (B) after removing the push rod pin (A).NOTE:
- Only remove the gas lifter when removing the whole trunk assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.