Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014EQUUS SIGNATUREREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPOWER TRUNK MODULEPOWER TRUNK MODULE DRIVE UNITREPAIR PROCEDURESINSTALLATION
2014 Hyundai Equus Signature
Repair procedures: Installation
2014 Hyundai Equus SignatureSECTION Installation
- Install the power trunk module & drive unit.
Tightening torque:
22 ~ 27 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)
- Install the push rod to the ball joint.
- Connect the connector (18P).
- Install the left trunk trim.
- Connect the negative (-) battery terminal and check the power trunk module correctly.NOTE:
- Connect the connectors tightly.
- Check the power trunk lid for normal operation correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.