Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ELANTRA SE, AUTOMATIC TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSAUTOMATIC TRANSAXLE CONTROL SYSTEMOUTPUT SPEED SENSORREPAIR PROCEDURESREMOVAL 2014
2014 Hyundai Elantra SE, Automatic Trans
Removal 2014
2014 Hyundai Elantra SE, Automatic TransSECTION Removal 2014
- Remove the valve body assembly.
(Refer to "VALVE BODY ")
- Disconnect the input & output speed sensor connector (A) from the main wiring.
- Remove the input & output speed sensor (B) after removing the bolts (2ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.