Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ELANTRA SE, AUTOMATIC TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE CONTROL SYSTEMINHIBITOR SWITCHREPAIR PROCEDURESINSTALLATION
2014 Hyundai Elantra SE, Automatic Trans
Repair procedures: Installation
2014 Hyundai Elantra SE, Automatic TransSECTION Installation
- Installation is the reverse of removal.NOTE:
- Use a SST (09480-A3800) or 0.1969in.(5mm) bolt fix the inhibitor manual control lever in the jig hole (A) when you assemble the inhibitor (B).
- Adjust the shift cable after you install the inhibitor switch.
(Refer to "SHIFT LEVER ")
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.