Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2014ELANTRA GT STANDARD TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSMANUAL TRANSAXLE CONTROL SYSTEMCONTROL CABLEREPAIR PROCEDURESINSTALLATION

2014 Hyundai Elantra GT Standard Trans

Repair procedures: Installation

2014 Hyundai Elantra GT Standard TransSECTION Installation

CAUTION:

When installing, set room side Shift lever and T/M side lever to N position.

Install the control cable (B) and clip (A) on the bracket.

Fig 1: Identifying Control Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Install the washer (B) and pin (A).

Fig 2: Identifying Washer And Pin
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the nut (B) after install the retainer (A).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 3: Identifying Retainer And Nut
Courtesy of HYUNDAI MOTOR AMERICA
Install the crash pad and cowl cross bar.
(Refer to "COWL CROSS BAR ASSEMBLY ")
Install the heater unit.
(Refer to "HEATER UNIT ")
Install the cable guide (B) on lever assembly.

Fig 4: Installing Cable Guide On Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) and clip (A).

Fig 5: Locating Shift Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Shift lever to "3rd".
Install the snap pin (A) after install the select cable (B).
CAUTION:
- Install the snap pin (A) after adjust the select cable (B).
  (Refer to "ADJUSTMENT ")

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.