Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ELANTRA GT STANDARD TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSMANUAL TRANSAXLE CONTROL SYSTEMCONTROL CABLEREPAIR PROCEDURESADJUSTMENTSELECT CABLE ADJUSTMENT
2014 Hyundai Elantra GT Standard Trans
Select cable adjustment
2014 Hyundai Elantra GT Standard TransSECTION Select cable adjustment
- Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
- Shift the shift lever to 3rd gear.
- Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.
- Install the select cable (A).
- Insert the slide clip (A) in the direction as shown in the illustration and then install the snap pin (B).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.