Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSMART KEY SYSTEMSMART KEY UNITCOMPONENTS AND COMPONENTS LOCATIONCOMPONENT (1)
2014 Hyundai Azera Limited
Component (1)
2014 Hyundai Azera LimitedSECTION Component (1)
CONNECTOR PIN INFORMATION
| Pin | Connector A | Connector B | Connector C | Connector D |
|---|---|---|---|---|
| 1 | Power GND1 | ACC | RF data | Antenna power - LH |
| 2 | Power GND2 | IGN2 | C CAN low | Antenna power - RH |
| 3 | - | Stop lamp fuse | B CAN low | Antenna power - Bumper |
| 4 | Starter relay | Driver toggle button | Immobilizer | Antenna power - Trunk |
| 5 | Vbat CPU | Assist toggle button | Demodulator power | Antenna power - Interior1 |
| 6 | Vbat Load | RPM | ESCL enable | Antenna power - Interior2 |
| 7 | ESCL GND | Wheel speed | SSB ACC LED | - |
| 8 | SSB illumication GND | - | SSB IGN LED | - |
| 9 | - | - | - | Antenna GND - LH |
| 10 | ACC relay | R position | - | Antenna GND - RH |
| 11 | IGN2 relay | - | C CAN hi | Antenna GND - Bumper |
| 12 | IGN1 relay | IGN1 | B CAN hi | Antenna GND - Trunk |
| 13 | SSB illumination Power | Start feedback | Immobilizer TXCT | - |
| 14 | ESCL battery | Stop lamp switch | EMS COM | - |
| 15 | - | ESCL COM | Antenna GND - Interior1 | |
| 16 | - | - | Antenna GND - Interior2 | |
| 17 | SSB1 | - | - | |
| 18 | SSB2 | RF enable | - | |
| 19 | - | Demodulator GND | ||
| 20 | - | SSB OFF LED | ||
| 21 | - | |||
| 22 | - | |||
| 23 | - | |||
| 24 | ESCL unlock |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.