Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014AZERA BASEREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMFUEL DELIVERY SYSTEMFUEL PUMPREPAIR PROCEDURESREMOVAL
2014 Hyundai Azera Base
Repair Procedures: Removal
2014 Hyundai Azera BaseSECTION Removal
- Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
- Remove the fuel pump service cover (A) in the trunk.
- Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
- Disconnect the fuel feed tube quick connector (C).
- Remove the fuel pump plate cover (D) after removing the bolts.
- Remove the fuel pump from the fuel tank.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.