Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014ACCENT SE, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 2)DTC P0136: O2 SENSOR CIRCUIT (BANK 1/SENSOR 2)VERIFICATION OF VEHICLE REPAIR
2014 Hyundai Accent SE, Automatic Trans
Verification of Vehicle Repair
2014 Hyundai Accent SE, Automatic TransSECTION Verification of Vehicle Repair
After a repair, it is essential to verifying that the fault has been corrected.
- Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
- Using GDS, Clear DTC.
- Operate the vehicle within DTC Enable conditions in General information.
- Are any DTCs present?
YES
- Go to the applicable troubleshooting procedure.
NO
- System is performing to specification at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.