2013 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Component Locations

Select a section or procedure below to view factory instructions:

Air Conditioning SystemAirbag Modules & Clock SpringAudio/Video/Navigation (AVN) SystemAuto Lighting Control SystemAutomatic Transaxle Control SystemAutomatic Transaxle Hydraulic SystemAutomatic Transaxle SystemBack View CameraBlower SystemBody Control Module (BCM)Button Engine Start SystemCharging SystemClutch & BrakeClutch SystemCylinder Block - Non-TurboCylinder Block - TurboCylinder Head Assembly - Non-TurboCylinder Head Assembly - TurboDisc Brake SystemDriveshaft AssemblyDual Clutch Transmission AssemblyDual Clutch Transmission Control SystemElectric Power SteeringElectronic Stability Control (ESC) SystemEmission Control System - Non-TurboEmission Control System - TurboEngine And Transaxle Assembly - Non-TurboEngine And Transaxle Assembly - TurboEngine Control System - Non-TurboEngine Control System - TurboEngine Cooling SystemExterior Body PanelsFront & Rear BumperFront Axle AssemblyFront Suspension SystemFuel Delivery System - Non-TurboFuel Delivery System - TurboFuses & RelaysHands Free SystemHeater & A/C Controller UnitHeater SystemHornImmobilizer SystemIndicators & GaugesIntake System & Exhaust System - Non-TurboIntake System & Exhaust System - TurboInteriorKeyless Entry & Burglar AlarmLighting SystemLubrication SystemManual Transaxle Control SystemManual Transaxle System - TurboManual Transaxle System - Non-TurboMobile TELEMETICS System (MTS)MULTIFUNCTION SwitchPANORAMAROOFParking Brake SystemPower Door LocksPower Door MirrorsPower WindowsRear Axle AssemblyRear Glass DefoggerRear Parking Assist SystemRear Suspension SystemRear Wiper & Washer SystemRestraintsSeat & Power SeatSeat Belt PRETENSIONERSeat BeltsSeat ElectricalSmart Key SystemStarting SystemSupplemental Restraint System Control Module (SRSCM) & SensorsTiming System - Non-TurboTiming System - TurboTire Pressure Monitoring System (TPMS)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.