2013 Hyundai Tucson GL, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Replacement

NOTE: In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together. (Refer to IMMOBILIZER SYSTEM or BUTTON ENGINE START SYSTEM .)
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the TCM Connector (A).
    Fig 1: Identifying TCM Connectors
    G06873203Courtesy of HYUNDAI MOTOR CO.
  3. Remove the battery. (Refer to CHARGING SYSTEM .)
  4. Remove the mounting bolts (A) and nut (B), and then remove the TCM (C).

    Tightening torque: 

    1. 21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)
    2. 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)
      Fig 2: Identifying TCM With Nut And Bolts
      G06873204Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.