Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (ENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (2 OF 3) - 2.0L)DTC P0463: FUEL LEVEL SENSOR 'A' CIRCUIT HIGH INPUTGROUND CIRCUIT INSPECTION
2013 Hyundai Genesis Coupe 2.0T Premium
Ground Circuit Inspection
2013 Hyundai Genesis Coupe 2.0T PremiumSECTION Ground Circuit Inspection
WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
- Check open in harness
- IG key "OFF"
- Disconnect Instrument cluster connector and main fuel level sender connector.
- Measure the resistance of both terminal of main fuel level sender harness.
Specification : Below 1Ω
- Is the resistance within specification?
YES
- Go to "COMPONENT INSPECTION "
NO
- Repair the open circuit of main fuel level sender and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.