SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2013GENESIS COUPE 2.0T PREMIUMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (ENGINE CONTROL SYSTEM (DTC TROUBLESHOOTING) (2 OF 3) - 2.0L)DTC P0461: FUEL LEVEL SENSOR 'A' CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION
2013 Hyundai Genesis Coupe 2.0T Premium

DTC P0461: Fuel Level Sensor 'A' Circuit Range/Performance: DTC Detecting Condition

2013 Hyundai Genesis Coupe 2.0T PremiumSECTION DTC Detecting Condition
WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Signal Stuck
  • Poor connection or damaged harness
  • Faulty Fuel Level Sender "A"
Enable Conditions
  • Cumulated Fuel Consumption > 30% (~ 20 liter of Tank capacity) -> can be cumulated over more than 1 Driving Cycles
  • No MIL illuminated for relevant DTCs
  • 11 < Battery voltage < 16
Threshold Value
  • Filtered FL signal change < 5 % after 30% calculated fuel consumption
Diagnostic Time
  • 20 liters fuel consumption
Mil On Condition
  • 2 * 30% Fuel Consumption
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.