2013 Hyundai Elantra GLS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair procedures: Installation

  1. Installation is the reverse of removal.
    NOTE:
    • Use a SST (09480-A3800) or 0.1969in.(5mm) bolt fix the inhibitor manual control lever in the jig hole (A) when you assemble the inhibitor (B).
      Fig 1: Jig Hole And Inhibitor
      G00559831Courtesy of HYUNDAI MOTOR AMERICA
    • Adjust the shift cable after you install the inhibitor switch.

      (Refer to "SHIFT LEVERΒ ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.