Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Hyundai Veracruz GLS, AWDFACTORY OEM SERVICE PROCEDURE
Body Control Module DTCS
BCM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B1602 | CAN ERROR |
| DTC B1603 | CAN BUS OFF |
| DTC B1605 | CAN Timeout Between BCM and DDM |
| DTC B1606 | CAN Timeout Between BCM and ADM |
| DTC B1607 | CAN Timeout Between BCM and PS |
| DTC B1608 | CAN Timeout Between BCM and TILT |
| DTC B1614 | CAN TIMEOUT BETWEEN BCM AND SMK |
| DTC B1630 | LIN Transmission Error |
| DTC B1640 | LIN RECEPTION ERROR FOR M/F SW |
| DTC B1642 | LIN RECEPTION ERROR FOR WMM |
| DTC B1901 | VA Sunlight Out Of Range |
| DTC B1905 | Rain Sensor Fault 1 |
| DTC B1906 | Rain Sensor Fault 2 |
| DTC B1907 | Rain Sensor Fault 3 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
