2012 Hyundai Veloster Standard TransFACTORY OEM SERVICE PROCEDURE

Heater Control Unit Replacement

CAUTION:
  • A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Put on gloves to protect your hands.
  1. Using a screwdriver or remover, remove the center facia panel (A).
    Fig 1: Identifying Center Facia Panel
    G08811218Courtesy of HYUNDAI MOTOR AMERICA
  2. Disconnect the heater control unit connectors (A).
    Fig 2: Identifying Heater Control Unit Connectors
    G08811219Courtesy of HYUNDAI MOTOR AMERICA
  3. After loosening the mounting screws, then remove the heater control unit (A).
    Fig 3: Identifying Heater Control Unit And Mounting Screws
    G08811220Courtesy of HYUNDAI MOTOR AMERICA
  4. Installation is the reverse of removal.
    NOTE:
    • Make sure the connector are connected in properly.
    • Replace any damaged clips.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.