2012 Hyundai Veloster Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver airbag module.

    (Refer to DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING )

  3. Remove the steering wheel.

    (Refer to the "STEERING COLUMN AND SHAFT ")

  4. Remove the steering wheel cover (A) after loosening 4 screws.
    Fig 1: Identifying Steering Wheel Cover With Mounting Screws
    G09134423Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the steering wheel remote control switches connectors.

    [LH-Audio/Bluetooth + Voice]Β 

    Fig 2: Identifying Steering Wheel Remote Control Switches Connectors (LH-Audio/Bluetooth + Voice)
    G09134424Courtesy of HYUNDAI MOTOR AMERICA

    [RH-Cruise/Trip + Reset]Β 

    Fig 3: Identifying Steering Wheel Remote Control Switches Connectors (RH-Cruise/Trip + Reset)
    G09134425Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the wiring and loosen 5 screws.
  7. Remove the steering wheel remote control switch assembly (A).
    Fig 4: Identifying Steering Wheel Remote Control Switch Assembly
    G09134426Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the bluetooth switch and the trip switch (A) after loosening the screws.
    Fig 5: Identifying Bluetooth Switch And Trip Switch
    G09134427Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.