Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Hyundai Tucson GLS, 4WDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Installation
- Installation is the reverse of removal.CAUTION: After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
- Continue to apply liquid gasket at application points at the valve body cover with Ø2.5 mm (0.0984 in.) thickness.
Liquid gasket Part name:
Threebond 1281B or LOCTITE FMD-546
- Adding automatic transaxle fluid. (Refer to AUTOMATIC TRANSAXLE SYSTEM .)
- Continue to apply liquid gasket at application points at the valve body cover with Ø2.5 mm (0.0984 in.) thickness.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.