Front Subframe: Service and Repair

Replacement

1. Remove the front wheel & tire.

Tightening torque :
88.3 - 107.9N.m(9.0 - 11.0Kgf.m, 65.1 - 79.6lb-ft)

CAUTION:
Be careful not to damage to the hub bolts when removing the front wheel & tire.

2. Disconnect the stabilizer link(B) with the front strut assembly(A) after loosening the nut.

Tightening torque :
98.1 - 117.7N.m(10.0 - 12.0Kgf.m, 72.3 - 86.8lb-ft)




3. Remove the spirit pin and castle nut and then disconnect the tie-rod end(A) from the front knuckle.

Tightening torque :
34.3 - 44.1N.m(3.5 - 4.5Kgf.m, 25.3 - 32.5lb-ft)




4. Loosen the bolt & nut and then remove the lower arm(A).

Tightening torque :
98.1 - 117.7N.m(10.0 - 12.0Kgf.m, 72.3 - 86.8lb-ft)




5. Loosen the nut and then remove the dust cover(A).




6. Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.

Tightening torque :
29.4 - 34.3N.m(3.0 - 3.5Kgf.m, 21.7 - 25.3lb-ft)





CAUTION:
Lock the steering wheel in the straight ahead position to prevent the damage of the clock spring inner cable when you handle the steering wheel.

7. Loosen the bolt(A) & nut(B) and then remove the roll rod stopper.

Tightening torque :
107.9 - 127.5N.m(11.0 - 13.0Kgf.m, 79.6 - 94.0lb-ft)




8. Disconnect the muffler rubber hanger(A).




9. Loosen the bolts & nuts and then remove the sub frame.

Tightening torque :
176.5 - 196.1N.m(18.0 - 20.0Kgf.m, 130.2 - 144.7lb-ft)




10. Remove the front lower arm.

11. Remove the front stabilizer.

12. Remove the steering gearbox.

13. Installation is the reverse of removal.
14. Check the alignment.