Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Hyundai Genesis 5.0FACTORY OEM SERVICE PROCEDURE
Tuner/Amplifier DTCS
TUNER/AMPLIFIER DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
| DTC U1000 | Amplifier Unit Error |
| DTC U1001 | HW Watchdog Executed |
| DTC U1004 | Temperature Sensor Signal Error in Tuner and Amplifier |
| DTC U1010 | Low Voltage Detected |
| DTC U1011 | High Voltage Detected |
| DTC U1138 | Fan Operation Error (Fan is running although should be off) |
| DTC U1139 | Fan Operation Error no plug put or line open Fan is not running although it should be on |
| DTC U1601 | Data Upgrade Error - Application Software Code 1 Missing or Corrupted |
| DTC U1602 | Data Upgrade Error - Application Software Code 2 Missing or Corrupted |
| DTC U1606 | Data Upgrade Error - Application Software Data Missing or Corrupted |
| DTC U1700 | DTCP Sink SW error |
| DTC U1702 | DTCP Sink Decode error |
| DTC U1710 | Amplifier stage group 1 Error - S/Woofer 1(+), 1(-) short circuit |
| DTC U1711 | Amplifier stage group 2 Error - S/Woofer 2(+), 2(-) short circuit |
| DTC U1712 | Amplifier stage group 3 Error - Front Middle Tweeter LH & RH short circuit |
| DTC U1713 | Amplifier stage group 4 Error DECK LH, DECK RH, Center Speaker short circuit |
| DTC U1714 | Amplifier stage group 5 Error - Front LH & RH short circuit |
| DTC U1941 | AM/FM Antenna circuit Open (not connected) |
| DTC U1942 | Fm2 Antenna circuit Low |
| DTC U1943 | Fm2 Antenna circuit Open |
| DTC U1944 | XM Antenna circuit Low (UTA US only) |
| DTC U1945 | XM Antenna circuit Open (UTA US only) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
