2012 Hyundai Genesis 5.0 R-SpecFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold (Refer to "INTAKE MANIFOLD " in EM group).
  3. Disconnect the knock sensor connector (A).

    [Bank 1] 

    Fig 1: Identifying Knock Sensor Connector (Bank 1)
    G08822876Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2] 

    Fig 2: Identifying Knock Sensor Connector (Bank 2)
    G08822877Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the cross over fuel pipe (A).
    Fig 3: Identifying Cross Over Fuel Pipe
    G08822878Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the installation bolt (A), and then remove the sensor from the cylinder block.
    Fig 4: Identifying Knock Sensor And Installation Bolt
    G08822879Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.