Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Hyundai Genesis 3.8FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Remove the front wheel guide [RH] (A).

Fig 1: Identifying Front Wheel Guide (RH)
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the fuel pump resister connector.
Remove the fuel pump resister (A) after removing the installation bolts (B).

Fig 2: Identifying Fuel Pump Resister And Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.