Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Hyundai Equus UltimateFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the center fascia panel (A). (Refer to Body group-"CRASH PAD ")

Fig 1: Identifying Center Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
Remove the DIS head unit (A). (Refer to DIS (Driver Information System) )

Fig 2: Identifying DIS Head Unit With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Remove the crash pad lower panel (A).

Fig 3: Identifying Crash Pad Lower Panel
Courtesy of HYUNDAI MOTOR AMERICA
Remove the power distribution module (A) after loosening bolt and nut.

Fig 4: Identifying Power Distribution Module

Courtesy of HYUNDAI MOTOR AMERICA

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.