2012 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable
  2. Remove the Engine room junction box after removing the cover.
    Fig 1: Identifying Engine Room Junction Box
    G08833099Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.

    Tightening torque:Β 

    12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

    Fig 2: Identifying Brake Tubes
    G08833100Courtesy of HYUNDAI MOTOR AMERICA
  4. Pull up the lock (A) of the ESC control unit connector, then disconnect the connector.
    Fig 3: Identifying ESC Control Unit Connector Lock
    G08833101Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the ESC HECU bracket bolts, then remove HECU and bracket.

    Tightening torque:Β 

    16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 112.3 ~ 18.8 lb-ft)

    Fig 4: Identifying HECU And Bracket
    G08833102Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the bolts, then remove the bracket from HECU.

    Tightening torque:Β 

    7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

    CAUTION:
    1. Never attempt to disassemble the HECU.
    2. The HECU must be transported and stored in.
    3. Never shock to the HECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.