Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
RLDM Power Window Function
Outputs the following control signals to S-ECU.
- RL Power window Enable, RLPower windowUp, RL Power window Down are controlled by remote request from DDM and RRDM via local communication and local SW.
Power window function is enabled/disabled by Power window Inhibit from DDM via local communication.
- Lamp are controlled by remote Signal from the Tail lamp Activity of DDM.
Outputs contol signals of illumination and ashtray lamp accoding to Tail Lamp Activity. (RL Illumination, RL Ashtray LAMP)
- Power window Enable/Disable Control
RLDM Power window function has Enable, Disable states.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.