2012 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

ADM Power Window Function

Power window lock switch indicator control

  • According to switch operation, indicator of power window lock switch is turned on/off to avoid miss-operation by user as follwing.

    Every time power window lock sw is pushed (OFF β†’ ON)

    Current state Output
    DDM inhibit Power window sw indication
    ON OFF
    Other Enable OFF
    OFF ON

Outputs the following control signals to S-ECU

  • Assist Power window Enable, Assist Power window Up, Assist Power window Down are controlled according to the remote switch from DDM via CAN, the status of local switch and IGN1 ADM.

    Power window function is enabled/disabled by Power window Inhibit from DDM via CAN.

  1. Power window Enable/Disable Control

    ADM Power window function has Enable, Disable states.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.