Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Hyundai Azera V6-3.3LFACTORY OEM SERVICE PROCEDURE
Smart Cruise Control Switch
Removal and Installation
1. Disconnect the negative battery cable.
2. Disconnect the driver air bag module.
3. Remove the steering wheel.
4. Loosen the screws and then remove the cover (A).
5. Disconnect the steering wheel remote control switch connectors (A).
6. Loosen the screw and then remove the steering wheel remote control switch assembly (A), being cautious of fixed clip.
7. Remove the smart cruise control switch (A).
8. Installation is reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.