Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2011TUCSON GL, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEMFUEL TANK PRESSURE SENSOR (FTPS)REPAIR PROCEDURESREMOVAL
2011 Hyundai Tucson GL, Automatic
Repair procedures: Removal
2011 Hyundai Tucson GL, AutomaticSECTION Removal
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Remove the rear seat. (Refer to REAR SEAT .)
- Remove the fuel pump service cover (A).
- Disconnect the fuel tank pressure sensor connector (A).
- Remove the fuel tank pressure sensor after releasing the hooks vertically.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.