Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2011SANTA FE GLS, 3.5 G, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3) - G3.5 DOHCDTC P0533: A/C REFRIGERANT PRESSURE SENSOR 'A' CIRCUIT HIGH INPUTINSPECTION/REPAIRCOMPONENT INSPECTION

2011 Hyundai Santa Fe GLS, 3.5 G, AWD

Component Inspection

2011 Hyundai Santa Fe GLS, 3.5 G, AWDSECTION Component Inspection

Check A/C pressure sensor

IG "OFF" and connect the scantool.
Connect the probe to A/C pressure sensor signal and select the oscilloscope in the menu.

Check the waveform with turning on and off a/c switch after engine start.

Specification :

VOLTAGE SPECIFICATIONS

Pressure (KPa)	392	1176	1961	2745	3138
Voltage (V)	1	2	3	4	4.5

Fig 1: Signal Waveform Data - A/C Pressure Sensor From Turning ON And OFF A/C Switch

Courtesy of HYUNDAI MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.