2011 Hyundai Equus UltimateFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Disassembly

  1. Drain the ATF by removing the drain plug and retighten the drain plug.
  2. Remove the manual shaft oil seal (A).
    Fig 1: Identifying Manual Shaft Oil Seal
    G07311633Courtesy of HYUNDAI MOTOR CO.
  3. Remove the oil pump oil seal. (A).
    Fig 2: Identifying Oil Pump Oil Seal
    G07311634Courtesy of HYUNDAI MOTOR CO.
  4. Remove the lock nut (A) using the special tool(09452-2J200).
    Fig 3: Removing Lock Nut Using Special Tool (09452-2J200)
    G07311635Courtesy of HYUNDAI MOTOR CO.
  5. Remove the plastic oil pan (A) by removing the special bolts (20ea) with TORX wrench(T40).
    NOTE: Be careful not to drop or damage to the plastic oil pan.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.