2011 Hyundai Equus UltimateFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the intake air temperature sensor connector (A) and remove the installation bolt (B).
    Fig 1: Identifying Intake Air Temperature Sensor Connector And Installation Bolt
    G07311510Courtesy of HYUNDAI MOTOR CO.
  3. Remove the intake air hose (A) and the resonator (B).

    (Refer to "INTAKE MANIFOLD " in EM group.)

  4. Remove the installation clamp (C), and then remove the sensor from the air cleaner assembly.
    Fig 2: Identifying Intake Air Hose, Resonator And Installation Clamp
    G07311511Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.