2011 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the connector after removing the front wheel speed sensor clip.
    Fig 1: Identifying Front Wheel Speed Sensor Clip Connector
    G07312236Courtesy of HYUNDAI MOTOR CO.
  2. Remove the front wheel speed sensor.

    (Refer to Driveshaft and Axle group - Front Axle assembly)

  3. Installation is the reverse of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.