Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Hyundai Azera LimitedFACTORY OEM SERVICE PROCEDURE

Component Locations

Select a section or procedure below to view factory instructions:

Air Conditioning Controller Air Conditioning System Airbag Modules Anti-Lock Brake System (Abs)Audio System Auto Lighting Control System Automatic Transaxle Control System Automatic Transaxle System Automatic Transaxle Valve Body System Blower System Bumpers Charging System Cylinder Block Cylinder Head Assembly Disc Brake System Driveshaft Assembly Electronic Stability Control (ESC) System Emission Control System Engine And Transaxle Assembly Engine Control System Components Engine Cooling System Exterior Body Panels Front Axle Assembly Front Suspension System Fuel Delivery System Fuel Filler Door Heater System Horn System Hydraulic Power Steering System Intake System And Exhaust System Interior Trim & Instrument Panel Keyless Entry And Burglar Alarm Lighting System Lubrication System Parking Brake System Power Door Locks Power Door Mirrors Rear Axle Assembly Rear Glass Defogger Rear Suspension System Restraint Seat & Power Seat Seat Belt Seat Belt PRETENSIONER Seat Electrical Starting System Steering Column & Shaft Sun Roof Supplemental Restraint System Control Module (SRSCM) & Sensors Timing System Tire Pressure Monitoring System Trunk Lid

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.