2011 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel (A). Avoid damaging retaining clip. (Refer to the CRASH PAD )
    Fig 1: Identifying Crash Pad Lower Panel
    G07250154Courtesy of HYUNDAI MOTOR CO.
  3. Remove ICM relay connector and 2 nuts.
    Fig 2: Identifying ICM Relay Connector
    G07250155Courtesy of HYUNDAI MOTOR CO.
  4. Remove the body control module (A) and tilt & telescope unit after loosening 2 nuts and disconnecting connector.
    Fig 3: Identifying Body Control Module
    G07250156Courtesy of HYUNDAI MOTOR CO.
  5. Remove the body control module (B) from the tilt & telescope unit (A) after loosening a bolt.
    Fig 4: Identifying Body Control Module And Tilt & Telescope Unit
    G07250157Courtesy of HYUNDAI MOTOR CO.
  6. Installation is the reverse of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.