Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Hyundai Accent GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
General Information (Fuel System): Specification: Actuators
Injector
- Number: 4
- Specification
COIL RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 13.8 ~ 15.2 [20 °C (68 °F)] |
Idle Speed Control Actuator (ISCA)
- Type: Double coil type
- Specification
IDLE SPEED CONTROL ACTUATOR (ISCA) RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Closing Coil Resistance (Ω) | 14.6 ~ 16.2 [20 °C (68 °F)] |
| Opening Coil Resistance (Ω) | 11.1 ~ 12.7 [20 °C (68 °F)] |
AIR FLOW RATE SPECIFICATIONS
| Duty (%) | Air Flow Rate (m3 /h) |
|---|---|
| 15 | 0.7 ~ 1.7 |
| 35 | 6.0 ~ 11.2 |
| 70 | 30.0 ~ 42.0 |
| 96 | 45.0 ~ 55.0 |
Purge Control Solenoid Valve (PCSV)
- Specification
PURGE CONTROL SOLENOID VALVE (PCSV) RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 14.0 ~ 18.0 [20 °C (68 °F)] |
CVVT Oil Control Valve (OCV)
- Specification
CVVT OIL CONTROL VALVE (OCV) RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 6.9 ~ 7.9 [20 °C (68 °F)] |
Canister Close Valve (CCV)
- Specification
CANISTER CLOSE VALVE (CCV) RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 23.0 ~ 26.0 [20 °C (68 °F)] |
Ignition Coil
- Type: Stick type
- Specification
IGNITION COIL RESISTANCE SPECIFICATIONS
| Item | Specification |
|---|---|
| Primary Coil Resistance (Ω) | 0.75 Ω ± 15% [20 °C (68 °F)] |
| Secondary Coil Resistance (kΩ) | Measurement is impossible because a diode is inserted |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.