2010 Hyundai Genesis 3.8FACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. Ignition "ON" & Engine "OFF".
  2. Connect scantool and check DTC.
  3. Erase the DTC with scantool.
  4. After turning IG OFF to IG ON twice or three times, check DTC again.
  5. Does the scantool show same DTC again?

    YES 

    • Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    How to perform Initial Learning

    If you replace the automatic transmission or TCU, or if you overwrite the TCU software, be sure to initialize the learned values and perform initial learning.

    1. Step 1) Warm-up

      Raise the ATF temperature by leaving the vehicle idling or performing city drive. Check the ATF temperature using the Scan-tool and make sure it is between 50°C (122°F) and 120°C (248°F). If the ATF temperature is outside this range, work to bring the range.

      CAUTION: Don't raise the oil temperature by stalling the engine.

      (Reference)

      If the oil temperature is not between 50°C (122°F) and 120°C (248°F), initial learning can not be performed. Before learning, check for variable speed shock or shift shock.

    2. STEP 2) Garage shift learning ("N→R", "N→D")

      With the vehicle standing still, depress the brake and keep the shift lever in "N" for 3 seconds. Then, shift from "N" into "D", and maintain this condition for 3 seconds.

      Repeat this procedure 5 times. Then repeat it 5 times in the same way for "R".

    3. STEP 3) Garage shift control learning

      In "D", with the throttle opening between 25 and 35%, drive until you reach 6th gear and a vehicle speed at 80Km/h or higher. Then, release the accelerator pedal and coast, and bring the vehicle to a stop in 60 seconds minimum. Repeat this procedure 10 times.

    4. STEP 4) Check learning results

    Check that variable speed shock and shift shock have decreased compared to conditions before learning.

    How to perform "N" position learning

    If you replace the automatic transmission or TCU, be sure to perform "N" position learning.

    1. Step 1) Shift to P range so that vehicle is in standstill. Turn IG ON but Engine is OFF.
    2. Step 2) After releasing shift lock, shift the shift lever to "N" position.
    3. Step 3) Install the SST on the shaft of inhibitor switch, and then, assemble the SST with alining neutral line on the SST with neutral line on the inhibitor switch.
    4. Step 4) Tighten the bolt after confirm the Neutral lines are aligned with.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.