2010 Hyundai Genesis 3.8FACTORY OEM SERVICE PROCEDURE

P0601 Internal Control Module Memory Check Sum Error: DTC Detecting Condition

DTC P0601 DETECTING CONDITION REFERENCE

Item Detecting Condition Possible Cause
DTC Strategy
  • Checksum
  • Faulty TCM
Enable Conditions
  • "IG KEY" ON
Threshold Value
  • Different from correct CHECKSUM value in flash ROM
Diagnostic Time
  • More than 1 time different value detection
Fail Safe
  • Fixed at 4th gear
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.