Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Hyundai Elantra GLSFACTORY OEM SERVICE PROCEDURE
Engine Control System
ENGINE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0011 | 'A' Camshaft Position-Timing Over-Advanced or System Performance (Bank1) |
| DTC P0030 | HO2S Heater Control Circuit (Bank 1 Sensor 1) |
| DTC P0031 | HO2S Heater Control Circuit Low (Bank 1 Sensor 1) |
| DTC P0032 | HO2S Heater Control Circuit High (Bank 1 Sensor 1) |
| DTC P0036 | HO2S Heater Control Circuit (Bank 1 Sensor 2) |
| DTC P0037 | HO2S Heater Control Circuit Low (Bank 1 Sensor 2) |
| DTC P0038 | HO2S Heater Control Circuit High (Bank 1 Sensor 2) |
| DTC P0076 | Intake Valve Control Solenoid Circuit-Low (Bank 1) |
| DTC P0077 | Intake Valve Control Solenoid Circuit-High (Bank 1) |
| DTC P0101 | Mass or Volume Air Flow A Circuit Range Performance |
| DTC P0102 | Massor Volume Air Flow Circuit Low Input |
| DTC P0103 | Massor Volume Air Flow Circuit high Input |
| DTC P0111 | Intake Air Temperature Sensor 1 Circuit Range Performance |
| DTC P0112 | Intake Air Temperature Sensor 1 Circuit Low Input |
| DTC P0113 | Intake Air Temperature Sensor 1 Circuit High Input |
| DTC P0116 | Engine Coolant Temperature Circuit Range Performance |
| DTC P0117 | Engine Coolant Temperature Circuit Low Input |
| DTC P0118 | Engine Coolant Temperature Circuit High Input |
| DTC P0121 | Throttle Pedal Position Sensor Switch A Circuit Range Performance |
| DTC P0122 | Throttle Position Sensor 1 Signal Circuit Low Input |
| DTC P0123 | Throttle Position Sensor 1 Signal Circuit High Input |
| DTC P0125 | Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC P0128 | Coolant Thermostat (Coolant Temperature below Thermostat Regulating Temperature) |
| DTC P0131 | O2 Sensor Circuit Low Voltage (Bank 1 Sensor 1) |
| DTC P0132 | O2 Sensor Circuit High Voltage (Bank 1 Sensor 1) |
| DTC P0133 | O2 Sensor Circuit Slow Response (Bank 1 Sensor 1) |
| DTC P0136 | O2 Sensor Circuit (Bank 1 Sensor 2) |
| DTC P0137 | O2 Sensor Circuit Low Voltage (Bank 1 Sensor 2) |
| DTC P0138 | O2 Sensor Circuit High Voltage (Bank 1 Sensor 2) |
| DTC P0139 | O2 Sensor Circuit Slow Response (Bank 1 Sensor 2) |
| DTC P0140 | O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 2) |
| DTC P0170 | Fuel Trim (Bank 1) |
| DTC P0171 | System too Lean (Bank 1) |
| DTC P0172 | System too Rich (Bank 1) |
| DTC P0196 | Engine Oil Temperature Sensor-Range Performance |
| DTC P0197 | Engine Oil Temperature Sensor Low Input |
| DTC P0198 | Engine Oil Temperature Sensor High Input |
| DTC P0230 | Fuel Pump Primary Circuit |
| DTC P0261 | Cylinder 1 Injector Circuit Low |
| DTC P0262 | Cylinder 1 Injector Circuit High |
| DTC P0264 | Cylinder 2 Injector Circuit Low |
| DTC P0265 | Cylinder 2 Injector Circuit High |
| DTC P0267 | Cylinder 3 Injector Circuit Low |
| DTC P0268 | Cylinder 3 Injector Circuit High |
| DTC P0270 | Cylinder 4 Injector Circuit Low |
| DTC P0271 | Cylinder 4 Injector Circuit High |
| DTC P0300 | Random Multiple Cylinder Misfire Detected |
| DTC P0301 | Cylinder 1-Misfire detected |
| DTC P0302 | Cylinder 2-Misfire detected |
| DTC P0303 | Cylinder 3-Misfire detected |
| DTC P0304 | Cylinder 4-Misfire detected |
| DTC P0315 | Crankshaft Position System Variation Not Learned |
| DTC P0325 | Knock Sensor 1 Circuit (Bank 1 or Single Sensor) |
| DTC P0335 | Crankshaft Position Sensor A Circuit |
| DTC P0340 | Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor) |
| DTC P0420 | Catalyst System Efficiency below Threshold (Bank 1) |
| DTC P0441 | Evaporative Emission System Incorrect Purge Flow |
| DTC P0442 | Evaporative Emission System-Leak detected (small leak) |
| DTC P0444 | Evaporative Emission System-Purge Control Valve Circuit Open |
| DTC P0445 | Evaporative Emission System-Purge Control Valve Circuit Shorted |
| DTC P0447 | Evaporative Emission System-Vent Control Circuit Open |
| DTC P0448 | Evaporative Emission System-Vent Control Circuit Shorted |
| DTC P0449 | Evaporative Emission System-Vent Valve Solenoid Circuit |
| DTC P0451 | Evaporative Emission System-Pressure Sensor Range Performance |
| DTC P0452 | Evaporative Emission System-Pressure Sensor Low Input |
| DTC P0453 | Evaporative Emission System-Pressure Sensor High Input |
| DTC P0454 | Evaporative Emission System-Pressure Sensor Intermittent |
| DTC P0455 | Evaporative Emission System-Leak detected (Large leak) |
| DTC P0456 | Evaporative Emission System-Leak detected (very small leak) |
| DTC P0501 | Vehicle Speed Sensor A Range Performance |
| DTC P0505 | Idle Air Control System |
| DTC P0506 | Idle Air Control System-RPM Lower than Expected |
| DTC P0507 | Idle Air Control System-RPM Higher than Expected |
| DTC P0560 | System Voltage |
| DTC P0562 | System Voltage Low |
| DTC P0563 | System Voltage High |
| DTC P0605 | Internal Control Module Read Only Memory (ROM) Error |
| DTC P0606 | ECM PCM Processor |
| DTC P0625 | Generator Field F Terminal Circuit Low |
| DTC P0626 | Generator Field F Terminal Circuit High |
| DTC P0630 | VIN Not Programmed or Incompatible-ECM PCM |
| DTC P0650 | Malfunction Indicator Lamp (MIL) Control Circuit |
| DTC P0700 | Transmission Control System (MIL Request) |
| DTC P1505 | Idle Speed Control Actuator Signal Low of Coil #1 |
| DTC P1506 | Idle Speed Control Actuator Signal High of Coil #1 |
| DTC P1507 | Idle Speed Control Actuator Signal Low of Coil #2 |
| DTC P1508 | Idle Speed Control Actuator Signal High of Coil #2 |
| DTC P2096 | Post Catalyst Fuel Trim System too Lean (Bank 1) |
| DTC P2097 | Post Catalyst Fuel Trim System too Rich (Bank 1) |
| DTC P2195 | O2 Sensor Signal Stuck Lean (Bank 1 Sensor 1) |
| DTC P2196 | O2 Sensor Signal Stuck Rich (Bank 1 Sensor 1) |
| DTC P2231 | O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 1 Sensor 1) |
| DTC P2237 | O2 Sensor Pumping Current Circuit Open (Bank 1 Sensor 1) |
| DTC P2243 | O2 Sensor Reference Voltage Circuit Open (Bank 1 Sensor 1) |
| DTC P2251 | O2 Sensor Reference Ground Circuit Open (Bank 1 Sensor 1) |
| DTC P2270 | O2 Sensor Signal Stuck Lean (Bank 1 Sensor 2) |
| DTC P2271 | O2 Sensor Signal Stuck Rich (Bank 1 Sensor 2) |
| DTC P2414 | O2 Sensor Exhaust Sample Error (Bank 1 Sensor 1) |
| DTC P2626 | O2 Sensor Pumping Current Trim Circuit Open (Bank 1 Sensor 1) |
| DTC U0001 | High Speed CAN Communication Bus off |
| DTC U0101 | Lost Communication With TCM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
