2010 Hyundai Elantra GLSFACTORY OEM SERVICE PROCEDURE

Repair procedures: Inspection: Notes

  1. Disconnect the spark plug cables from the spark plugs.
    NOTE: When removing the spark plug cable, pull on the spark plug cable boot (not the cable), as it may be damaged.
  2. Using a spark plug socket, remove all spark plugs from the cylinder head.
    CAUTION: Be careful that no contaminants enter through the spark plug holes.
  3. Check the spark plugs for the following:
    1. Broken insulator
    2. Worn electrode
    3. Carbon deposits
    4. Damaged or broken gasket
    5. Condition of the porcelain insulator at the tip of the spark plug
      Fig 1: Checking Spark Plugs
      G06863069Courtesy of HYUNDAI MOTOR CO.
  4. Check the spark plug gap using a wire gap (A) gauge, and adjust if necessary.

    Standard value:Β  1.0-1.1 mm (0.039-0.043 in)

    Fig 2: Checking Spark Plug Gap Using Wire Gap Gauge
    G06863070Courtesy of HYUNDAI MOTOR CO.
  5. Re-insert the spark plug and tighten to the specified torque.

    If it is over torqued, damage to the threads of the cylinder head may result.

    Tightening torque:Β 

    20-30 Nm (2.0-3.0 kgf.m, 15-21 lb-ft)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.