2010 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE

Connector Inspection Procedure

  1. Handling of Connector
    1. Never pull on the wiring harness when disconnecting connectors.
      Fig 1: Precaution - Never Pull On Wiring Harness When Disconnecting Connectors
      G06805015Courtesy of HYUNDAI MOTOR CO.
    2. When removing the connector with a lock, press or pull locking lever.
      Fig 2: Pressing Or Pull Connector Locking Lever
      G06805016Courtesy of HYUNDAI MOTOR CO.
    3. Listen for a click when locking connectors. This sound indicates that they are securely locked.
      Fig 3: Listening For Click When Locking Connectors
      G06805017Courtesy of HYUNDAI MOTOR CO.
    4. When a tester is used to check for continuity, or to measure voltage, always insert tester probe from wire harness side.
      Fig 4: Inserting Tester Probe From Wire Harness Side
      G06805018Courtesy of HYUNDAI MOTOR CO.
    5. Check waterproof connector terminals from the connector side. Waterproof connectors cannot be accessed from harness side.
      Fig 5: Checking Waterproof Connector Terminals From Connector Side
      G06805019Courtesy of HYUNDAI MOTOR CO.
Chapter Navigation
Return to Chapter: Basic Troubleshooting
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.