Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Hyundai Tucson GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE DTC (LIST)
| DTC No. | DESCRIPTION | MIL(1) | ||
|---|---|---|---|---|
| P0560 | Back-Up BATTERY LINE OPEN | OFF | ||
| P0605 | EEPROM Abnormal | OFF | ||
| P0703 | BRAKE SWITCH CIRCUIT | OFF | ||
| P0707 | TRANS. RANGE SENSOR-LOW | ON | ||
| P0708 | TRANS. RANGE SENSOR-HIGH | ON | ||
| P0711 | FLUID TEMPERATURE. SENSOR RATIONALITY | OFF | ||
| P0712 | FLUID TEMPERATURE. SENSOR CIRCUIT-LOW | ON | ||
| P0713 | FLUID TEMPERATURE. SENSOR CIRCUIT-HIGH | ON | ||
| P0715 | INPUT SPEED SENSOR CIRCUIT | ON | ||
| P0720 | OUTPUT SPEED SENSOR CIRCUIT | ON | ||
| P0731 | Gear 1 Incorrect Ratio | ON | ||
| P0732 | Gear 2 Incorrect Ratio | ON | ||
| P0733 | Gear 3 Incorrect Ratio | ON | ||
| P0734 | Gear 4 Incorrect Ratio | ON | ||
| P0736 | REVERSE INCORRECT RATIO | ON | ||
| P0741 | Torque Converter Clutch Circuit Stock off | ON | ||
| P0742 | Torque Converter Clutch Circuit Stock on | ON | ||
| P0743 | DCC (TCC) Solenoid - Open or ground short (Torque Converter Clutch Circuit Electrical) | ON | ||
| P0750 | LR Solenoid - Open or ground short (SCSV "A" CIRCUIT MAL.) | ON | ||
| P0755 | UD Solenoid - Open or ground short (SCSV "B" CIRCUIT MAL.) | ON | ||
| P0760 | 2ND Solenoid - Open or ground short (SCSV "C" CIRCUIT MAL.) | ON | ||
| P0765 | OD Solenoid - Open or ground short (SCSV "D" CIRCUIT MAL.) | ON | ||
| P0885 | A/T RELAY CIRCUIT MAL | ON | ||
| P1500 (2.7) P0500 (2.0) |
VEHICLE SPEED SENSOR CIRCUIT | ON | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
