Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Hyundai Tucson GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Abs DTCS
ABS DIAGNOSTIC TROUBLE CODE DTC (LIST)
| DTC | DESCRIPTION |
|---|---|
| C1101 | Battery voltage high |
| C1102 | Battery voltage low |
| C1200 | Wheel speed sensor FR-LH open/short |
| C1201 | Wheel speed sensor FR-LH range/performance/intermittent |
| C1202 | Wheel speed sensor FR-LH invalid/no signal |
| C1203 | Wheel speed sensor FR-RH open/short |
| C1204 | Wheel speed sensor FR-RH range/performance/intermittent |
| C1205 | Wheel speed sensor FR-RH invalid/no signal |
| C1206 | Wheel speed sensor RR-LH open/short |
| C1207 | Wheel speed sensor RR-LH range/performance/intermittent |
| C1208 | Wheel speed sensor RR-LH invalid/no signal |
| C1209 | Wheel speed sensor RR-RH open/short |
| C1210 | Wheel speed sensor RR-RH range/performance/intermittent |
| C1211 | Wheel speed sensor RR-RH invalid/no signal |
| C1604 | ECU hardware error |
| C2112 | Valve relay error |
| C2380 | ABS/TCS/ESC valve error |
| C2402 | Motor - electrical |
| C1274 | G sensor - electrical (4WD) |
| C1275 | G sensor - signal (4WD) |
| C1503 | TCS switch error |
| C1605 | CAN hardware error |
| C1611 | CAN time-out EMS |
| C1612 | CAN time-out TCU |
| C1613 | CAN wrong message |
| C1616 | CAN bus off |
| C2227 | Excessive temperature of brake disc |
| C1112 | Sensor source voltage |
| C1235 | Primary pressure sensor - electrical |
| C1237 | Primary pressure sensor - signal |
| C1259 | Steering angle sensor - electrical |
| C1260 | Steering angle sensor - signal |
| C1282 | Yaw rate & lateral G sensor-electrical |
| C1283 | Yaw rate & lateral G sensor - signal |
| C1513 | Brake switch error |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
