Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Hyundai Entourage V6-3.8LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
Connecting rod
Connecting rod big end inner diameter 58.000 - 58.018mm (2.2834 -2.2842in.)
Connecting rod bearing oil clearance 0.038 - 0.056mm (0.0015 - 0.0022in.)
Side clearance 0.1 - 0.25mm (0.0039 - 0.0098in.)
Connecting rod bearing bolt 19.60 Nm + 90° (2.0 kgf.m + 90°, 14.46 lb-ft + 90°)
Connecting rod big end inner diameter 58.000 - 58.018mm (2.2834 -2.2842in.)
Connecting rod bearing oil clearance 0.038 - 0.056mm (0.0015 - 0.0022in.)
Side clearance 0.1 - 0.25mm (0.0039 - 0.0098in.)
Connecting rod bearing bolt 19.60 Nm + 90° (2.0 kgf.m + 90°, 14.46 lb-ft + 90°)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.