Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
IPM (In-Panel Module)
2008 Hyundai Entourage V6-3.8LSECTION IPM (In-Panel Module)
IPM (IN-PANEL MODULE)
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel (A).
3. Remove the keyless antenna cable and IPM (Instrument Panel Module)(A) after loosening 3 nuts and disconnecting 5 connectors.
4. Installation is the reverse of removal.
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel (A).
3. Remove the keyless antenna cable and IPM (Instrument Panel Module)(A) after loosening 3 nuts and disconnecting 5 connectors.
4. Installation is the reverse of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.